Thank you for visiting Rosie On The House, the online home to Arizona's longest running weekend radio broadcast!


Share on facebook
Share on twitter
Share on linkedin


If you’ve spilled nail polish on your finished wood floor, you’re probably going to remove part of that finish when you remove the nail polish. So our friends at Rosie Certified East Valley Floors suggest that you try the following to remove the dried-on nail polish:

  • Using a clean, white towel, or even a Q-tip, dab a bit of rubbing alcohol on the spot before you put anything harsher on your delicate finish.

NOTE: Before you apply the alcohol to your spot, test it on a piece of scrap wood or on an area of your floor that’s covered by a piece of furniture, or is inside a closet or under an area rug.

If rubbing alcohol doesn’t remove the nail polish:

  • Dab the stain with mineral spirits; a mild, petroleum-based solvent that painters sometimes use instead of turpentine to clean paint brushes.

NOTE: Be careful not to spill the solvent on the unstained area of your floor, as it might remove the finish.

Still no luck? Break out the nail-polish remover, but use a non-acetone-based brand. If that still doesn’t do the trick, try an acetone-based nail polish, but be aware that it’s going to take the finish off of your floor along with the polish. Lacquer thinner will work much the same way. Control the amount of solvent used to an area no bigger than the stain itself so a minor repair doesn’t turn into a major refinishing job. 

If you’re careful to dab just the polish and not the surrounding floor, you will create only a small area of damage to the floor. Lightly sand the unfinished area and then recoat it with an oil-based urethane, using a narrow, artist’s paint brush. 


  • Sanderson Ford

Find Rosie-Certified Contractors in your area today

All contractors are Rosie-Certified for the state of Arizona.

Others Articles from Flooring
More Flooring Articles

Explore Other Categories

Display More
  • Sanderson Ford

Event Promotion Request

  • This field is for validation purposes and should be left unchanged.