Thank you for visiting Rosie On The House, the online home to Arizona's longest running weekend radio broadcast!


“Clay suction begins from around the perimeter of a foundation & brings water (and other vapors) underneath the slab. This may result in a foundation heave.”

– Bob Brown, Foundation Repair Expert & owner of Arizona Foundation Solutions

Foundation Heave is the uplift of the foundation caused by wet, expanding soil beneath a slab floor. This uplift occurs when it is dry outside your foundation and wet underneath it.
Foundation heave and settlement have very similar symptoms. Here is what to look for:

  • Stair-step cracks in brick or concrete block foundation walls
  • Leaning, tilting chimneys
  • Cracks around doors and windows
  • Jamming, sticking doors and windows
  • Cracks in a concrete slab floor
  • Cracks in drywall

Concrete is poured with an excess of water, typically called water of convenience, that does not bind with the cement particles. This excess water takes many years to remove itself. In addition, there are number of mechanisms that bring water under the slab. One such mechanism is clay suction from around the perimeter of a foundation. In addition, through the “stack effect”, water vapor along with other gases is pulled in from around the perimeter of a structure to replace gases that are transmitted up through the foundation into the structure and by heat convection drawn up into the attic. This is a well-documented process for one of those gases, radon. To learn more about Radon Mitigation, click here.

Particularly here in the arid Southwest and Sonoran Desert, air-conditioning dries the surface of the slab promoting vapor transmission as well as condensation of water vapor as it is pulled through the slab. As water condenses the pH level is usually around seven, which can promote dissolution and attacking of cement particles causing great greater voids in the concrete thus exacerbating the problem. Once this process has begun de-bonding of most surface treatments becomes more problematic over time.

Most solutions to this problem involve installing sealers on the surface of the concrete. This is problematic at best for the following reasons:

  • Hydrostatic pressure can be a very powerful force and is likely over time to build up and become strong enough to the bond almost any coating or floor treatment.
  • In order for sealing to be effective all floor coverings and all fixtures must be removed including kitchen, baths, built-in desks, and all cabinets. If this is not done than the vapor transmission becomes concentrated where it is not applied creating mold problems.
  • The inconvenience of removing everything necessitates full move out and accommodations to live and or work somewhere else until the project is done.
  • The cost of such a project is very expensive.

The problem here in the Southwest is exacerbated by the reluctance of installers to install a vapor barrier under the slab. Because of the arid hot curing conditions, placing a vapor barrier underneath a slab promotes extreme slab curling due to the difference of evaporation on the sealed bottom versus the open top.

Fortunately, we do have a solution that offers some foundation heave protection. The MoistureLevel® Smart Foundation System dries out expansive clay soils beneath the foundation slab and corrects foundation heave. We developed the MoistureLevel® Smart Foundation System to alleviate expansive soil problems beneath concrete slab foundations. This foundation repair technique borrows from reliable radon mitigation technology, using a vacuum and ventilation pipe to create air movement as well as suction on the under-slab soil. Introducing outside air to the damp soil causes evaporation to take place, making it possible to reduce soil moisture content and (as a result) damaging soil expansion.

Symptom Photos:


Arizona Foundation Solutions serves the Greater Phoenix & Statewide areas, providing long-term solutions for structures with foundation problems. Owner, Robert Brown brings over 30 years of construction experience. He is LEED Accredited and one of 2 Certified Foundation Repair Specialists (CFRS) in the State of Arizona. CFRS is a Designation of the Foundation Repair Association. Arizona Foundation Solutions also performs radon testing and radon mitigation in Arizona.

June Home Maintenance To-Do | #HeaveWave

Find Rosie-Certified Contractors in your area today

All contractors are Rosie-Certified for the state of Arizona.

Others Articles from Foundations & Settling

Explore Other Categories

DYI Categories Filter
Display More

Leave a Reply

Your email address will not be published. Required fields are marked *

Event Promotion Request

  • This field is for validation purposes and should be left unchanged.